World Wide Garage
  Forum     Blog     Login  


Home > User galleries > crzn427 > Inside View

This is a view of the bow mounts I had "mashed" at the fab shop, in their metal break. I need a curved cross section on the end to "nest" with the bow for a good conection. Previously I would spend about an hour, doing it with a hammer and round rod, for each end. That didn't include the time to put a final finish on the piece either There is one shown finished, it took considerably less time to make it than my old method. There is an end view of one of the "mashed" pieces at the bottom of the plywood.
Rate this file (No vote yet)
Rubbish
Poor
Fair
Good
Excellent
Great